How to extend a data volume in Windows Server

How to extend a data volume in Windows Server

How to use Diskpart.exe to extend a data volume in Windows Server 2003, in Windows XP, and in Windows 2008

You can use the Diskpart.exe utility to manage disks,   partitions, and volumes from a command-line interface. You can use Diskpart.exe   on both Basic disks and Dynamic disks. If an NTFS volume resides on a hardware   RAID 5 container that can add space to the container, you   can extend the NTFS Volume with Diskpart.exe while the disk remains a Basic   disk.
Use the extend command to incorporate unallocated space into an existing volume   while preserving the data.
The following are the requirements for the   extend command:

• The volume must be formatted with the NTFS file system.
• For Basic volumes, the unallocated space for the extension must be the next contiguous space on the same disk.
• For Dynamic Volumes, the unallocated space can be any empty area on any Dynamic disk on the system.
• Only the extension of data volumes is supported. System or boot volumes may be blocked from being extended, and you may receive the following error:
  Diskpart failed to extend the volume. Please make sure the volume is valid for extending
• You cannot extend the partition if the system page file is located on the partition.  Move the page file to a partition that you do not want to extend.

To extend a partition or volume, you must first select the   volume to give it the focus, and then you can specify how large to make the   extension. To extend a volume, follow these steps:

1. At a command prompt, type diskpart.exe.
2. Type list volume to display the existing volumes on the computer.
3. Type Select volume volume number where volume number is number of the volume that you want to extend.
4. Type extend [size=n] [disk=n] [noerr]. The following describes the parameters:
   size=n The space, in megabytes (MB), to add to the current partition. If you do not specify a size, the disk is extended to use all the next contiguous unallocated space.
   disk=n The dynamic disk on which to extend the volume. Space equal to size=n is allocated on the disk. If no disk is specified, the volume is extended on the current disk.
   noerr For scripting only. When an error is thrown, this parameter specifies that Diskpart continue to process commands as if the error did not occur. Without the noerr parameter, an error causes Diskpart to exit with an error code.
5. Type exit to exit Diskpart.exe.

When the extend command is complete, you should receive a message that states   that Diskpart successfully extended the volume. The new space should be added   to the existing drive while maintaining the data on the volume.
Note In   Windows XP and in  Windows 2000, you cannot use Diskpart.exe to extend a simple volume on a Dynamic disk that was originally created on a Basic disk. You can extend only simple volumes that were created after the disk was upgraded to Dynamic disk. If you try to extend a simple volume on a Dynamic disk that was originally created on a Basic disk, you receive the following error message. This restriction was removed in  Windows Server 2003.